How to Fix a Hole in a Pocket

Posted by Anonymous , 9/5/2007 Tags:FixHolePocket
Post By :
Anonymous
Rate:
Vote

How to Fix a Hole in a Pocket

Introduction

There are almost as many kinds of pockets as there are types of garments--patch pockets and inside pockets, in-seam and slashed, lined and unlined. Though each presents slightly different challenges, the following basic techniques will work for almost any pocket that hangs inside the garment. So before you lose any more loose change, try these simple repairs.

Instructions

Difficulty: Moderate

Steps

1

Step One

Turn the pocket inside out. Determine whether the hole was caused by a ripped seam or by a hole in the fabric of the pocket itself.

Fixing a hole in a pocket seam

Steps

1

Step One

Pick out any bits of loose thread from the split seam.
2

Step Two

Match the raw edges of the fabric together where the seam is coming apart. Pin the fabric into place.
3

Step Three

Thread a needle with thread that matches the color of the inside of the pocket. Tie a knot at the end of the thread.
4

Step Four

Click to enlarge
Starting 1/2 inch (12 mm) to the right of where the seam is coming apart, begin stitching the fabric together from right to left using a whipstitch (see A): Pull the needle up through both layers of fabric with the needle at a slant, just a few threads from the edge. Loop the needle over the top of the seam to the back side of the fabric.
5

Step Five

Repeat the whipstitch, making about 15 stitches per inch (2.5 cm), until you've reached the point 1/2 inch (12 mm) to the left of where the seam is coming apart. It won't be pretty, but the whipstitch is strong, and the thread will be hidden inside the pocket when you're done.
6

Step Six

Tie a knot in the thread, and snip off the thread with scissors.

Fixing a hole in the pocket fabric

Steps

1

Step One

Cut a patch large enough to cover the hole with 3/4 inch (2 cm) extra fabric all around. You can use any fabric of similar weight to the pocket lining.
2

Step Two

Click to enlarge
Turn the edges of the patch under 1/4 inch (6 mm), ironing the wrong sides together, so you have a patch that is 1/2 inch (12 mm) larger than the hole on every side (see B).
3

Step Three

Center the patch over the hole in the pocket, and pin it into place with straight pins.
4

Step Four

Fold the pocket fabric level with one edge of the patch and whipstitch the edges together, making about 10 to 15 stitches per inch (2.5 cm).
5

Step Five

When you reach the corner, refold the pocket fabric and continue stitching the next side, until all sides are stitched.
6

Step Six

Tie a small knot and snip off the extra thread, close to the knot you just made.

Overall Tips & Warnings

  • These techniques will work even if the garment is lined and you don't have easy access to the back side of the pocket fabric. If you can get to the back side of the pocket fabric, you can make a less conspicuous repair.

Overall Things You'll Need

  • Thread
  • Scissors
  • Needle
  • Fabric To Cover The Hole
  • Straight Pins
  • Iron
Tools: |