How to Carve Using Marble Stone

Posted by Anonymous , 9/4/2007 Tags:CarveUsingMarbleStone
Post By :
Anonymous
Rate:
Vote

How to Carve Using Marble Stone

Introduction

Marble has been a traditional carving stone for centuries and remains a favorite today. Marble is an example of metamorphic rock, a soft stone to carve. The colors widely vary depending on what part of the world it comes from. One of the well known characteristics of marble is the ability to provide a very glossy shine.

Instructions

Difficulty: Moderately Challenging

Carve a Sculpture Using Marble Stone

Steps

1

Step One

Put on eye goggles, ear plugs and a dust mask before you begin to carve. This paraphernalia protects your health and hearing as you work. Heavy work gloves are recommended to avoid cutting your hands on shards of marble.
2

Step Two

Determine the direction of the grain, or bed, of your stone. The composition of marble, a metamorphic rock, is layer upon layer. The layering makes it easy to find the grain. It looks similar to the grain in a piece of wood.
3

Step Three

Mark the area of stone that you will not be using. Use a pencil or crayon to avoid bleeding ink into the marble.
4

Step Four

Use sandbags to absorb vibrations when using a hammer or drill on your stone. Place them underneath the marble.
5

Step Five

Discard large portions of stone that you do not want. One way to perform this function is with a grinder using a diamond blade. An alternative is to drill a hole in the middle of the unwanted area, then use a pitcher and hammer to break off the stone.
6

Step Six

Define the shape you want the marble to take with a point chisel. Hold it at a 45-degree angle as you hit it with the hammer.
7

Step Seven

Follow the point with tools with teeth such as claws and tooth chisels. This defines the shape further and will start to smooth out the marble.
8

Step Eight

Smooth the marks left by the toothed implements with rasps and files, also called rifflers. Because marble is a soft stone, a lot of the detailed carving work can be done with files.
9

Step Nine

Sand your marble sculpture with numerous grades of wet/dry sand paper. Begin with the coarsest grade first--usually 120 or 150--and gradually use finer grades until you are satisfied with the quality of shine. This step is very labor intensive, as you may use up to 3000 grade paper.
10

Step Ten

Let your marble sculpture dry after sanding.
11

Step Eleven

Put on rubber gloves and dissolve oxalic acid into warm water. You can find oxalic acid at the drugstore.
12

Step Twelve

Dip a piece of felt into the oxalic acid and rub onto the sculpture. This seals the marble and serves to protect it from staining.
13

Step Thirteen

Wait a few minutes after applying the oxalic acid, then wash it off the marble.
14

Step Fourteen

Wax your sculpture with a clear paste wax, buffing it to a high polish with a soft cloth.

Overall Tips & Warnings

  • Be sure the change the water with each grade of sand paper you use, to avoid scratching your sculpture with remnants of the previous paper.

Overall Things You'll Need

  • Clear paste wax
  • Rubber gloves
  • Soft cloth
  • Hammer
  • Drill
  • Points
  • Ear plugs
  • Sandbags
  • Sandpaper
  • Dust mask
  • Marble slab
  • Chisels
  • Grinder saw
  • Pencil or crayon
  • Rasps
  • Pitcher
  • Work gloves
  • Goggles
  • Oxalic acid
  • Claws
Tools: |